Pro Intercom Blazon4 Top Mounted Xenon Strobe Light

The Pro Intercom Blazon4 is a top - mounted xenon strobe light and it's Pro Intercom's most popular beacon. It features a 2Hz flash rate, giving 8 flashes per cycle. There are two 3 - pin XLR connectors on the rear panel. By default, the female connector serves as the input, and the male one is for looping to the next station in the system. In ready mode, it consumes 21.1mA, and 120mA when the strobe is active. Technical specs include a supply voltage of 24 - 30 VDC nominal, a switch - on voltage of at least 8 Volts, a switch - off voltage of at most 5 Volts, a switch - on time of 75 milliseconds, and a switch - off time of 4 seconds. The flash rate is 2Hz with a flash power of 0.75 joules. It has an input impedance of 1 Meg Ohm, and power consumption is 21.1mA in ready mode and 68 mA for the strobe only. Its size is 3.70x4.30x5.80 in. (93.98x109.22x147.32 mm) and it weighs 20oz. (0.567Kg).

Using the Pro Intercom Blazon4 strobe light is easy. First, make sure the supply voltage is within the 24 - 30 VDC nominal range. Connect the input using the female 3 - pin XLR connector on the rear panel. If you want to loop it to another station in the system, use the male connector. When you turn it on, wait at least 75 milliseconds for it to start flashing. It'll flash at a rate of 2Hz, giving 8 flashes per cycle. When you're done, it'll take about 4 seconds to switch off. Just note that the minimum switch - on voltage is 8 Volts and the maximum switch - off voltage is 5 Volts. As for maintenance, keep it in a dry place. Check the connectors regularly to make sure they're clean and in good condition. If you notice any power consumption issues, check the voltage supply. This light has a size of 3.70x4.30x5.80 in. and weighs 20oz, so handle it with care.